1C1955603 Windshield Wiper Linkage for VW Beetle 1998-2010

Brand-new OE-quality wiper linkage assembly for VW Beetle 1998-2010 (replaces OE 1C1955603). Supplied complete with links, pivots and crank arm, and it bolts onto the factory mounting points using the original wiper motor. Factory-direct wholesale supply for importers and distributors — MOQ 10 pcs.

Description

This wiper linkage covers the VW Beetle (1998-2010) and replaces OE 1C1955603, 1C1955603A. Same footprint as the original part, with the pivot design reworked where the factory unit tends to fail.

Uneven wiping, a blade that lags on one side, or a knock on every pass usually traces back to worn pivots rather than the motor. If the linkage is left in place, the extra load is passed on to the motor and gearbox.

Vehicles this wiper linkage fits

Make / model Model years
Volkswagen Beetle 1998-2010
Volkswagen Beetle Cabrio 2010

Replaces OE numbers: 1C1955603, 1C1955603A. If the number on your old linkage matches, this is the correct replacement.

New Beetle (1998-2010): retro body, modern linkage access

The Beetle’s curved body hides a conventional Golf-platform linkage, but the cowl sits lower and the trim panels are distinctive to the model. Bush wear is the standard failure; water and age contribute on the later cars.

  • Golf-family geometry. The mechanism is close to the 1C Golf parts family — the Beetle stamping still decides the order.
  • Curved cowl trim is fragile. The panels are model-specific and brittle with age; work the clips gently.
  • Bushes wear normally. Expect the usual symptoms: arm lag, then a scuttle knock.
  • Motor and crank reused. Rods, pivots and bracket supplied.

Confirm before ordering

Check What to look for
OE number 1C1955603 on the old assembly — also 1C1955603 variants; match the suffix
Generation 1998-2010 Beetle. Confirm against the stamping rather than the year alone
Trim care The curved cowl panels crack if flexed — support them on removal
Arm marks Tape both arms at park

Why the original part fails

On a high-mileage vehicle the linkage outlives the bushings inside it. Once a pivot stiffens, every sweep pulls harder on the motor, and the wiper arm timing drifts out of position.

  • POM bushings, DuPont grade — The original soft bushings wear oval and let the pivot move off-centre. A harder, dimensionally stable bushing keeps the clearance the linkage was designed with.
  • Brass bearings at the pivot pins — Carries the load at the point where the factory part scores, so service life is not limited by a single wear surface.
  • Aluminium pivot arms — Adds stiffness to the linkage under load — this is what stops the assembly flexing and skipping.
  • Galvanised and coated steel — Water from the windscreen drains straight over this area. Coated rods and brackets resist rust and seizing in wet climates.
  • Pre-greased on assembly — The unit goes in ready to run, so there is no extra greasing step during fitting.

Specification

OE number 1C1955603, 1C1955603A
Vehicle VW Beetle (1998-2010)
Bushings POM (DuPont grade) with brass bearings
Pivot arms Aluminium, re-engineered design
Finish Galvanised and coated, anti-rust
Mounting Direct bolt-on to original points
Greasing Pre-greased at assembly
Testing 100% inspected before shipment
Packing Neutral carton or customer-branded
Warranty 12 months

Symptom to cause

Symptom on the car What is worn Does this part fix it?
Arm lag on one side Oval bush Yes
Clunk per stroke Pin play Yes
Heavy sweep in rain Stiff joints Yes, motor permitting
Streaks only Blades No

Fitting outline

  1. Battery off; arms tape-marked.
  2. Arm caps and nuts off; arms drawn with a puller.
  3. Curved cowl panels supported and removed.
  4. Bracket unbolted; assembly out; crank transferred.
  5. New assembly seated; bracket evened.
  6. Arms to the marks; cycle run; park adjusted if needed.

Detail and photographs: how to replace a wiper linkage on your car.

Frequently asked questions

What is the usual lead time?

Lead time depends on quantity and whether you need neutral or branded packing. Send us the quantity and your destination port and we will confirm the schedule in the quotation.

Do you cover other models from the same platform?

Very often yes — several vehicles share the same linkage. If you tell us the models you buy for, we will check the full cross-reference and bundle them into one shipment.

How do I confirm this VW Beetle linkage is the right part?

Match the OE reference 1C1955603, 1C1955603A against the number stamped or printed on your original linkage. If your part carries a superseded number, send us a photo of it and we will confirm the match before you order.

Is this the same as the Golf 4 part?

It is Golf-platform related but carries its own stamping. Order by the number on the old Beetle assembly, not by the platform.

Any special tools?

Standard puller and trim tools only. The curved cowl panels need patience more than equipment.

Request a quote

Send us the OE number, the quantity you need and your destination port, and we will come back with price, MOQ and lead time. If you are sourcing a range of wiper linkages rather than a single part, ask for our full cross-reference list — we cover VW, Audi, Seat, Skoda, Ford, Toyota, Honda, Hyundai, Nissan and Opel applications.

Factory-direct, OE cross-referenced — see our wholesale terms. Mechanism background: how a wiper linkage works.

Related wiper linkages and vehicle series

This VW Beetle 1998-2010 assembly is part of our VW Series wiper linkages range. Also stocked in the same series: VW Touareg 2005-2014 wiper linkage (7L0955601C) and VW Sharan 1995-2010 wiper linkage (7M1955603). For fitment guidance and fault diagnosis, see the complete wiper linkage replacement guide. Every assembly ships with its OE cross-reference, so you can order by the number stamped on the old unit.

Additional information

Position

Front

Material

Aluminium + POM bushings

Warranty:

12 months

Minimum Order Quantity:

10 pcs

Packaging Details:

Carton of 10-20 pcs depending on size

Delivery Time:

7-30 days

Payment Terms:

T/T 30% deposit, balance before shipment

Place of Origin:

Made in China

Model Number:

1C1 955 603, 1C1 955 603 A, 1C1955603, 1C1955603A, 602-602

Reviews

There are no reviews yet.

Be the first to review “1C1955603 Windshield Wiper Linkage for VW Beetle 1998-2010”

Your email address will not be published. Required fields are marked *

6 − 5 =

Ask For A Quick Quote

We will contact you within 1 working day, please pay attention to the email with the suffix “@fengteautoparts.com”.