Description
This wiper linkage is a direct bolt-on replacement for the VW Polo (2001-2012). It carries OE reference 6Q1955601, 6Q1955601B, 6Q1955603A and mounts to the original fixing points, so no drilling or adapter plates are needed.
The failure mode is predictable — a binding pivot, a rusty rod end or cracked plastic bushing. Replacing the whole assembly is normally quicker and safer than pressing in new bushings on a scored pin.
Vehicles this wiper linkage fits
| Make / model | Model years |
|---|---|
| VW Polo 2001-2012 | 2001-2012 |
Replaces OE numbers: 6Q1955601, 6Q1955601B, 6Q1955603A. If the number on your old linkage matches, this is the correct replacement.
Polo 9N (2001-2012): small car, tight tolerances
The Polo 9N’s linkage is a compact Golf-family unit with the same sealed-pivot philosophy as its bigger siblings. On a small screen the tolerances are tighter — a little bush wear shows up in the sweep pattern sooner than on a big car.
- Tight geometry. Small clearances matter; replace the assembly rather than patching single joints.
- City-car damage pattern. Parking knocks and hooded arms bend rods more often than bushes wear them.
- Easy access. The 9N cowl comes off quickly — an under-hour job.
- Motor and crank reused. Rods, pivots and bracket supplied.
Four checks before you order
| Check | What to look for |
|---|---|
| OE number | 6Q1955601 on the old assembly — match the suffix where present |
| Generation | 2001-2012 Polo 9N family; confirm against the stamping |
| Damage vs wear | Bent rods point to impact; oval bushes point to age |
| Arm marks | Tape both arms before removal |
Why the original part fails
Most failures on this type of assembly start at the pivots: the bushings dry out, water works into the joint and the pin starts to seize. The symptom shows up first as a smeared arc at the edge of the screen.
- POM bushings, DuPont grade — The original soft bushings wear oval and let the pivot move off-centre. A harder, dimensionally stable bushing keeps the clearance the linkage was designed with.
- Brass bearings at the pivot pins — Carries the load at the point where the factory part scores, so service life is not limited by a single wear surface.
- Aluminium pivot arms — Adds stiffness to the linkage under load — this is what stops the assembly flexing and skipping.
- Galvanised and coated steel — Water from the windscreen drains straight over this area. Coated rods and brackets resist rust and seizing in wet climates.
- Pre-greased on assembly — The unit goes in ready to run, so there is no extra greasing step during fitting.
Specification
| OE number | 6Q1955601, 6Q1955601B, 6Q1955603A |
|---|---|
| Vehicle | VW Polo (2001-2012) |
| Bushings | POM (DuPont grade) with brass bearings |
| Pivot arms | Aluminium, re-engineered design |
| Finish | Galvanised and coated, anti-rust |
| Mounting | Direct bolt-on to original points |
| Greasing | Pre-greased at assembly |
| Testing | 100% inspected before shipment |
| Packing | Neutral carton or customer-branded |
| Warranty | 12 months |
Symptoms and causes
| Symptom on the car | What is worn | Does this part fix it? |
|---|---|---|
| Sweep out of step | Oval bush | Yes |
| One arm touched the bonnet | Bent rod | Yes — new straight rods |
| Knock per stroke | Pin play | Yes |
| Streaks only | Blades | No |
Fitting outline
- Battery off; arms tape-marked.
- Arm caps and nuts off; small arms drawn with a puller.
- Cowl panel removed.
- Bracket unbolted; assembly out; crank transferred.
- New assembly seated; bracket bolts evened.
- Arms to the marks; cycle run; park corrected if needed.
Photographs and detail: replacing a wiper linkage.
Frequently asked questions
What is the usual lead time?
Lead time depends on quantity and whether you need neutral or branded packing. Send us the quantity and your destination port and we will confirm the schedule in the quotation.
Do you cover other models from the same platform?
Very often yes — several vehicles share the same linkage. If you tell us the models you buy for, we will check the full cross-reference and bundle them into one shipment.
How do I confirm this VW Polo linkage is the right part?
Match the OE reference 6Q1955601, 6Q1955601B, 6Q1955603A against the number stamped or printed on your original linkage. If your part carries a superseded number, send us a photo of it and we will confirm the match before you order.
My Polo’s arm got knocked in a car park — is the linkage bent?
Very possibly. On small cars an arm impact travels into the rods. Roll the rods on a flat surface; if either rocks, the assembly has bent rods and full replacement is the clean fix.
Is this the Polo 6R part?
No — the 6R moved to a different assembly. Match the stamped number on the old unit.
Request a quote
Send us the OE number, the quantity you need and your destination port, and we will come back with price, MOQ and lead time. If you are sourcing a range of wiper linkages rather than a single part, ask for our full cross-reference list — we cover VW, Audi, Seat, Skoda, Ford, Toyota, Honda, Hyundai, Nissan and Opel applications.
Manufactured on our own line — see MOQ and lead times. For the mechanism: how a wiper linkage works.
Related wiper linkages and vehicle series
This VW Polo 2001-2012 assembly is part of our VW Series wiper linkages range. Also stocked in the same series: VW Touareg 2005-2014 wiper linkage (7L0955601C) and VW Sharan 1995-2010 wiper linkage (7M1955603). For fitment guidance and fault diagnosis, see the complete wiper linkage replacement guide. Every assembly ships with its OE cross-reference, so you can order by the number stamped on the old unit.








Reviews
There are no reviews yet.