Description
A replacement wiper linkage for the VW Octavia, cross-referenced to OE 5E1955203A. Supplied as a complete linkage assembly, ready to bolt on without modification.
Most failures on this type of assembly start at the pivots: the bushings dry out, water works into the joint and the pin starts to seize. The symptom shows up first as a smeared arc at the edge of the screen.
Vehicles this wiper linkage fits
| Make / model | Model years |
|---|---|
| VW Octavia | – |
Replaces OE number: 5E1955203A. If the number on your old linkage matches, this is the correct replacement.
Octavia 5E: modern MQB linkage, modern failure modes
The third-generation Octavia shares its linkage family with other MQB cars, and like them it fails from water, not from cycles. The pivot design is sealed and robust — until standing water in the wiper well finds its way in.
- Standing water is the killer. Blocked drains under the cowl keep the pivots wet; the joints seize and the sweep goes heavy.
- Sealed design means no field re-bushing. Replacement is assembly-only, which is how the car was engineered.
- Access is straightforward. Arms off, cowl panel off, bracket out — under an hour for an experienced hand.
- Motor and crank stay on the car. Rods, pivots and bracket supplied.
Before you order
| Check | What to look for |
|---|---|
| OE number | 5E1955203A on the old assembly — match the full suffix |
| Generation | Octavia 5E (2013-on). The Octavia II takes 1Z1955601 — a different part |
| Drains | Check the cowl drains; clearing them protects the new assembly |
| Arm marks | Tape both arms at park before removal |
Why the original part fails
The failure mode is predictable — a binding pivot, a rusty rod end or cracked plastic bushing. Replacing the whole assembly is normally quicker and safer than pressing in new bushings on a scored pin.
- POM bushings, DuPont grade — The original soft bushings wear oval and let the pivot move off-centre. A harder, dimensionally stable bushing keeps the clearance the linkage was designed with.
- Brass bearings at the pivot pins — Carries the load at the point where the factory part scores, so service life is not limited by a single wear surface.
- Aluminium pivot arms — Adds stiffness to the linkage under load — this is what stops the assembly flexing and skipping.
- Galvanised and coated steel — Water from the windscreen drains straight over this area. Coated rods and brackets resist rust and seizing in wet climates.
- Pre-greased on assembly — The unit goes in ready to run, so there is no extra greasing step during fitting.
Specification
| OE number | 5E1955203A |
|---|---|
| Vehicle | VW Octavia |
| Bushings | POM (DuPont grade) with brass bearings |
| Pivot arms | Aluminium, re-engineered design |
| Finish | Galvanised and coated, anti-rust |
| Mounting | Direct bolt-on to original points |
| Greasing | Pre-greased at assembly |
| Testing | 100% inspected before shipment |
| Packing | Neutral carton or customer-branded |
| Warranty | 12 months |
Symptom to cause
| Symptom on the car | What is worn | Does this part fix it? |
|---|---|---|
| Heavy, slow sweep after rain | Water-seized pivots | Yes |
| One arm lagging | Oval bush | Yes |
| Knock per stroke | Pivot pin play | Yes |
| Streaking only | Blades | No |
Fitting outline
- Battery off; arms tape-marked.
- Arm caps and nuts off; arms drawn with a puller.
- Cowl panel removed; drains cleared.
- Bracket unbolted; assembly out; crank transferred from the motor.
- New assembly seated; bracket bolts tightened evenly.
- Arms to the marks; cycle tested; park corrected if needed.
Full procedure with photographs: how to replace a wiper linkage on your car.
Frequently asked questions
How do I confirm this VW Octavia linkage is the right part?
Match the OE reference 5E1955203A against the number stamped or printed on your original linkage. If your part carries a superseded number, send us a photo of it and we will confirm the match before you order.
Is the wiper motor included in this listing?
This listing covers the linkage itself. Several of our linkages are also available as a linkage-with-motor assembly — tell us the vehicle and we will quote both options.
Can you supply this in bulk for distribution?
Yes. This is a volume part for the aftermarket and we supply importers, distributors and workshop chains with mixed container loads. Urgent orders are accepted and samples can be arranged.
Is this the same as the Octavia II part?
No — the 5E takes 5E1955203A and the Octavia II takes 1Z1955601. The two generations do not interchange.
How do I keep the new one alive?
Clear the cowl drains every service and keep jet-washers off the scuttle line. Water management is the whole game on MQB-era linkages.
Request a quote
Send us the OE number, the quantity you need and your destination port, and we will come back with price, MOQ and lead time. If you are sourcing a range of wiper linkages rather than a single part, ask for our full cross-reference list — we cover VW, Audi, Seat, Skoda, Ford, Toyota, Honda, Hyundai, Nissan and Opel applications.
Factory-direct, OE cross-referenced — see our wholesale terms. For the mechanism: how a wiper linkage works.
Related wiper linkages and vehicle series
This Skoda Octavia assembly is part of our VW Series wiper linkages range. Also stocked in the same series: Skoda 1998-2010 wiper linkage (1U1955603C) and Skoda 1999-2008 wiper linkage (6Y1998023). For fitment guidance and fault diagnosis, see the complete wiper linkage replacement guide. Every assembly ships with its OE cross-reference, so you can order by the number stamped on the old unit.






Reviews
There are no reviews yet.